Network Technologies ST-C5VA-WL500 User Manual download pdf (Page 13)

NTI XTENDEX Wall Mount Extenders

INTERCONNECTION CABLE WIRING METHOD

The CAT5 connection cable between the remote and local is terminated with RJ45 connectors and must be wired according to the

EIA/TIA 568 B industry standard. Wiring is as per the table and drawing below.

Pin Wire Color Pair Function

1 White/Orange 2 T

2 Orange 2 R

3 White/Green 3 T

4 Blue 1 R

5 White/Blue 1 T

6 Green 3 R

7 White/Brown 4 T

8 Brown 4 R

Figure 8- View looking into RJ45 female

Note: Shielded

CAT 5,5e, or 6 cable must be used to connect to LOCAL and REMOTE units in order to meet CE emission

requirements.

Note: CAT5 connection cable used between NTI XTENDEX Series Local and Remote or any XTENDEX Series products

should not be run underground, outdoors or between buildings.

WARNING: Outdoor or underground runs of CAT5 cable could be dangerous and will void the warranty.

TROUBLESHOOTING

Each and every piece of every product produced by Network Technologies Inc is 100% tested to exacting specifications. We

make every effort to insure trouble-free installation and operation of our products. If problems are experienced while installing this

product, please look over the troubleshooting chart below for answers any questions that might arise. If the answer is not found

in the chart, please check the FAQs (Frequently Asked Questions) at our website at http://www.networktechinc.com or contact us

directly for help at 1-800-742-8324 (800-RGB-TECH) in US & Canada or 1-330-562-7070 worldwide. We will be happy to assist

in any way we can.

Problem Cause Solution

Remote or Local Unit

power indicator LED does

not illuminate

• Power supply is not connected or

plugged-in.

• Make sure outlet is live and AC adapter is plugged-in.

• Make sure 12VDC power connector is fully inserted

• Make sure CAT5 cable is connected at both ends

(Remote Unit is powered via the CAT5 cable)

No Video on monitor

• One or more video cables is loose

or disconnected.

• No power to Remote or Local

Units.

• Video Cable was not attached

when CPU was booted.

• CAT5 cable is not connected.

• Check all video cable connections

• Make sure power LEDs are illuminated for Local and

Remote (green LEDs). If not, see solutions for first two

problems above.

• With all the cables properly connected, reboot the CPU.

• Check cable connections. Make sure they are snapped-

in properly and completely and reboot.

Pair 2 Pair 1

Pair 4

Pair 3

1 2 ... 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Network Technologies ST-C5VA-WL500 User Manual Page 13

Comments to this Manuals