Network Technologies ST-C5KVM2ARS-1000S User Manual download pdf (Page 11)

NTI XTENDEX Extenders

Green Power LED

Yellow Traffic LED

CAT5 Cable to

Remote Unit

XTENDEX

NTI

Network Technologies Inc

Rear View

ST-C5KVM2ARS-1000S Local Unit

d) If the Local Unit has RS232 support, connect the local user's RS232 cable from a touch screen

monitor to the RJ45 port on the Local Unit using the DB9M-to-RJ45 adapter and patch cable provided.

e) If the Local Unit has audio support, connect the cable from the local speakers to the 3.5mm

stereo audio jack with the speaker symbol on the Local Unit. (See Fig. 4) Connect a microphone to the

3.5mm stereo audio jack with the microphone symbol on the Local Unit.

Figure 4- Connect stereo speakers and microphone to XTENDEX Local Unit with audio support

Note: When two microphones are connected (one at local and one at remote), only one can be active at a time. See

mode charts on pages 12 and 13 for active microphone selection.

Connect The CAT5 Cable

Connect the CAT5 cable to the “Cat 5” port on the Local Unit. (See Fig. 5.) When properly inserted the cable end

should snap into place.

Note: If an RJ45 wall outlet is being used, connect the other

end of the extension cable to the RJ45 wall outlet.

WARNING: Never connect the XTENDEX to an Ethernet

card, Ethernet router, hub or switch or other Ethernet RJ45 connector

of an Ethernet device. Damage to devices connected to the Ethernet

may result.

Figure 5- Connect CAT5 cable to Local Unit

Stereo

Speakers

XTENDEX

NTI

Network Technologies Inc

Microphone

Rear View

ST-C5KVM2ARS-1000S Local Unit

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

No comments

Network Technologies ST-C5KVM2ARS-1000S User Manual Page 11